Graffiti
Removal Steps for
X-Off Coated Surfaces
Step 1
When removing graffiti from an affected area, always start from the top of
the graffiti and work downward. Let the Special Cleaning Agent work for
you by allowing the Special Cleaning Agent to wash the graffiti downward
off the vertical surface. Press the spray trigger on the applicator with
sufficient pressure to force the Special Cleaning Agent into the valleys
between any ridges. Spray the area as close as necessary to clean out any
pockets of trapped graffiti.
Step 2
The Special Cleaning Agent will remove some graffiti on initial contact: however,
some graffiti will require the Special Cleaning Agent to be left on for
a longer time before you can begin to loosen and remove the graffiti. If
the Special Cleaning Agent does not begin to loosen the graffiti immediatey,
wait for 1-2 minutes before agitating the graffiti with a brush. Work the
Special Cleaning Agent into the graffiti by scrubbing or agitation as necessary
with a brush until all is loosened. Wipe area with a clean rag.
Step 3
If needed, reapply the Special Cleaning Agent as in Step 1 to the entire area
to ensure that all of the graffiti is completely loosened. This will liquify
the graffiti and improve the removal. If necessary, use a stiff nylon brush
to remove any faint shadowing of graffiti. Wipe area with clean rag. If
necessary rinse again with the Special Cleaning Agent. Inspect for complete
removal.
Step 4
When the surfaced is completely clean of graffiti, rinse the surface with water.
A low-pressure sprayer is usually adequate although moderately high pressure
can improve the removal of paint that may be trapped in surface pores.
Step 5
Water deactivates the Special Cleaning Agent. If further removal is needed
because some minor shadowing was not removed during the original Special
Cleaning Agent application, make sure the surface is thoroughly dry before
applying additional Special Cleaning Agent. The Special Cleaning Agent
can be applied again to the surface but only after the surface has been
completely dried.
Notes:
Do not
dilute the Cleaning Agent.
Wear protective gloves and eye wear when using Special Cleaing Agent. Wash
hands with soap and water after use
